Skip to topic | Skip to bottom
Home"Wealth without money..."


Support This Project

  • Main Web
  • Changes
  • Changes detailed
  • Topic list
  • Search

    • login

    Main.StripboardBipolarSlaveStepperControllerr1.2 - 01 Apr 2006 - 09:20 - SimonMcAuliffetopic end
    Start of topic | Skip to actions

    HOWTO: Build A Stripboard Bipolar Slave Stepper Controller

    Introduction

    The Stepper Slave is used in conjuction with a stepper controller to allow control of multiple motors that run in unison.

    Requirements

    Tools and consumables

    • A soldering iron and accessories (see Electronics Fabrication Guide).
    • Solder
    • Electric drill or at least a suitable drill bit
    • Some wire for jumpers/links
    • Wire strippers
    • Small pliers or tweezers

    Components

    • C1 0.1μF
    • C2 0.1μF
    • U1 SN754410 (or a stack of two SN754410s, see below)

    Schematic

    Preparing the board

    Making the board

    Component side of board

    Board connections

    Variations

    Troubleshooting

    If you experience trouble, please share the problems (and resolutions) with us.

    Testing The Unit

    See Also

    -- SimonMcAuliffe - 30 Mar 2006
    to top

    End of topic
    Skip to action links | Back to top

    Edit | Attach image or document | Printable version | Raw text | More topic actions
    Revisions: | r1.3 | > | r1.2 | > | r1.1 | Total page history | Backlinks | Refresh
    You are here: Main > ToDoList > RepStrap > StripboardBipolarStepperController > StripboardBipolarSlaveStepperController

    to top

    Copyright © 1999-2010 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
    Ideas, requests, problems regarding RepRap? Send feedback